How do I setup Bleed in my InDesign Document?

Adobe
2018-05-01 09:23

To print to the paper’s edge without any margins around your design, first extend your design into a bleed area so it’s slightly larger than your finished print size. You’ll then add print crop marks, which show where to trim the paper to the document’s finished print size. Your design should extend past these crop marks. The excess will be trimmed off after it’s printed, and your design will cover the entire page.

Set up bleed when you create your document

If you know your design will extend to the paper’s edge, you can set up the bleed area right when you create your document.

Select the Print tab at the top. In Preset Details, choose your preferred measurement units.

Scroll, and then click Bleed and Slug to expand the panel. Type a bleed value in any units. For example, you can type 0.125 in or 3 mm even if your document uses picas or something else. Set the same bleed on all sides, or click the chain icon to set different values for the top, bottom, inside, and outside settings.


Note: Bleed values of 3mm are an industry standard. Flare Print requires 3mm minimum outside bleed on all documents / artwork.

Optionally, you can include job notes and instructions for your printer in a slug area that typically extends beyond the bleed area. The slug is also trimmed off.

Set up bleed at any time

You can always add a bleed area to your document later, or edit bleed settings you entered previously.


Choose File > Document Setup. Click Bleed and Slug to expand it, and then enter your values.

Align your artwork to the bleed guides

Place your artwork on the page and position it so its edges align with the bleed guides. Objects snap easily to the guides, so you can be assured your artwork will print correctly.

Preview the printed document

Now that you have some artwork aligned to the bleed guides, you can see how it will appear when printed and trimmed to its final size.

Long-press on Mode at the bottom of the Tools menu and choose Bleed from the drop-down menu. This special preview mode displays all the printing objects within and including the bleed area. Choose Preview to see how your document will look trimmed.

 See Also: How do I Export a .pdf file with 'bleed' in InDesign?

Average rating: 0 (0 Votes)

You cannot comment on this entry